Copeland select 6 software


















System Requirements:. Install Now Contact Support. Custom Features. Product Performance This option provides compressor performance, operating envelope, exporting of compressor coefficients, estimation of electrical current and condenser heat rejection.

Product Information This option provides compressor performance along with information such as access to reference drawings, wiring diagrams, and brazed plate heat exchanger selection for vapor injected compressors. Annual Energy Analysis This function allows users to estimate annual energy usage by a single or a group of compressors using the weather data for over US and international locations.

Our Products. In addition the whole of the cylinder head is covered by suction channels except a small port in the center of each head where the discharge pipes is attached. This construction of the suction channels result in the outside of the compressor to be surprisingly cool.

If the suction gas is cool, lets say C, then it is fully possible to have a negative compressor heat loss factor! It is absolutely unnessecarry with a cooling fan on these compressors when running at low suction temperatures as the plant room temperature is normally warmer than most of the surface of the compressor! It does however not do this, the software calculates the heat loss factor to zero independent of the suction temperature. The same shortcoming applyes to the Copeland selection software.

The upper compressor body and the compressor head will be warmer at any condition due to different suction channel layout, both in the compressor body and in the cylinder head, on this Copeland compressor compared with the Dorin compressor. It is maybe not possible with negative heat loss factor, and the heat loss factor will be higher under equal operating conditions. The conclusion is that if the "in house" Copeland selection software has the same flawed equations to calculate the "heat rejection" value as the comercially available software has, then the discharge temperature returned by that "in house" software us without any value whatsoever.

With all energy calculations we have to make certain assumptions. We may use 36C in summer to base our calculations or 21C in colder climates. The result is a vastly different calculation. We may calculated an entering load at kg when the actual load ends up at kg. The same with condenser and evaporator.

An online version of Select 8 can also be accessed directly from the web. Online access guarantees that the very latest data is always at hand. Features Download Select 8. Find the best match for your needs Simply choose a tab to find compressors or condensing units, choose the families from which to make the selection, choose refrigerant and required capacity.

To make the installation: Click on the download link, and download the installation file into a temporary location on your hard disk. Select Software: also available as online version An online version of Select 8 can also be accessed directly from the web.

Select Online can be accessed from PCs and from hand-held smartphones. Our Products. Our Industries.



0コメント

  • 1000 / 1000